CONTROL EDGE RTU CODE

arithmetic/logic unit (ALU), memory, and input/outputДҐ9.Which one of the following is not a vectored interrupt?Д¦0. control and timing, register, and memoryД. control and timing, register, and arithmetic/logic unit (ALU)Д¬. operand, register, and arithmetic/logic unit (ALU)Д«. Which of the following are the three basic sections of a microprocessor unit?ДЄ.

CONTROL EDGE RTU CODE

Which of the following buses is primarily used to carry signals that direct other ICs to find out what type of operation is being performed?ДҐ7.What kind of computer program is used to convert mnemonic code to machine code?ДҐ8. Machine codes are in shorthand English, mnemonic codes are in binary.ДҐ6. Machine codes are in binary, mnemonic codes are in shorthand English.Д¬. In max mode, control bus signal So,S1 and S2 are sent out in _formДҐ1.What type of circuit is used at the interface point of an input port?ДҐ2.Because microprocessor CPUs do not understand mnemonics as they are, they have to be converted to _.ДҐ3.A register in the microprocessor that keeps track of the answer or results of any arithmetic or logic operation is the:ДҐ4.What is the difference between a mnemonic code and machine code?Д«. If MN/MX is low the 8086 operates in_modeДҐ0. In a minimum mode there is a_on the system busД¤9. The RD, WR, M/IO is the heart of control for a_modeД¤8. The functions of Pins from 24 to 31 depend on the mode in which_is operatingД¤7. The address bits are sent out on lines throughA. The pin of minimum mode AD0- AD15 has _data busД¤4. The pin of minimum mode AD0-AD15 has_addressД¤3. The_is required to synchronize the internal operands in the processor CLK SignalД¤2. The BIU contains FIFO register of size 6 bytes calledД¤1. The 8086 fetches instruction one after another from_of memoryД¤0. The_contains an offset instead of actual addressДЈ9. The_translates a byte from one code to another codeДЈ8. The LES copies to words from memory to register andДЈ7. The microprocessor determines whether the specified condition exists or not by testing theДЈ6. The conditional branch instruction specifyДЈ5. Instruction providing both segment base and offset address are calledДЈ4. INC destination increments the content of destination byДЈ1._destination inverts each bit of destinationДЈ3. LDs copies to consecutive words from memory to register andДў9. The push source copies a word from source toДў8. The CS register stores instruction in code segmentДў7. The 1 MB byte of memory can be divided into segmentДў5. The BIU prefetches the instruction from memory and store them inДў3. The BIU contains FIFO register of sizeДў2. the condition of result of ALU operationДЎ6. The 16 bit flag of 8086 microprocessor is responsible to indicateДЄ. In 8086 microprocessor, the address bus is bit wideДЎ1. The microprocessor can read/write 16 bit data from or toД©. The intel 8086 microprocessor is a processorДЁ. The first digital electronic computer was built in the yearД§. The purpose of the microprocessor is to controlДҐ. Microprocessor is the _ of the computer and it perform all the computational tasksД¤. Microprocessor is a/an_circuit that functions as the CPU of the computeДЈ. A microprocessor is a_ chip integrating all the functions of a CPU of a computer.Дў.

Control edge rtu